I have started the HP pump but I am waiting for a bearing. So, I will change my plans and start working on the rear right quarter.
Here is the suspension cylinder...
The piston had some markings. After some fine sanding and polishing...
Done. I have replaced the electrical tape on the boot to protect the boot against the ligarex.
Jumping to the brakes; clean and in good shape...
... except for the inside of the cylinder. It was very dirty and scored.
Some honing is required.
I've used some 600 grid sand paper to smooth out the bore...
... and restored the pistons also.
Done.
Here is the suspension cylinder...
The piston had some markings. After some fine sanding and polishing...
Done. I have replaced the electrical tape on the boot to protect the boot against the ligarex.
Jumping to the brakes; clean and in good shape...
... except for the inside of the cylinder. It was very dirty and scored.
Some honing is required.
I've used some 600 grid sand paper to smooth out the bore...
... and restored the pistons also.
Done.
No comments:
Post a Comment